Balboa CLIM8ZONE II User And Service Manual page 5

Spa heat pump
Hide thumbs Also See for CLIM8ZONE II:
Table of Contents

Advertisement

DANGER
: Risk of Electric Shock. Install at least 5 feet (1.5 m) from inside wall of hot tub or spa using
nonmetallic plumbing.
DANGER –
Risk of Electric Shock. Install at least 5 feet (1.5 m) from all metal surfaces. As an
alternative, a spa may be installed within 5 feet of metal surfaces if each metal surface is
permanently connected by a minimum 6 AWG (13.3 mm2) solid copper conductor to the wire
connector on the terminal box that is provided for this purpose.
DANGER –
Risk of Electric Shock. Do not permit any electric appliance, such as a light, telephone,
radio, or television, within 5 feet (1.5 m) of a spa.
WARNING – To reduce the risk of injury:
a) The water in a spa should never exceed 40° C (104° F). Water temperatures between 38°C
(100°F) and 40°C are considered safe for a healthy adult. Lower water temperatures are
recommended for young children and when spa use exceeds 10 minutes.
b) Since excessive water temperatures have a high potential for causing fetal damage during the
early months of pregnancy, pregnant or possibly pregnant women should limit spa water
temperatures to 38°C (100°F).
c) Before entering a spa or hot tub, the user should measure the water temperature since the
tolerance of water temperature-regulating devices varies.
d) The use of alcohol, drugs, or medication before or during spa or hot tub use may lead to
unconsciousness with the possibility of drowning.
e) Obese persons and persons with a history of heart disease, low or high blood pressure,
circulatory system problems, or diabetes should consult a physician before using a spa.
f) Persons using medication should consult a physician before using a spa or hot tub since some
medication may induce drowsiness while other medication may affect heart rate, blood pressure,
and circulation.
Caution: The user is cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt RSS(s) and Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference, including interference that may cause undesired operation
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) L'appareil ne doit pas produire de brouillage;
(2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
5

Advertisement

Table of Contents
loading

Table of Contents