Balboa CLIM8ZONE II User And Service Manual page 14

3. Change temperature unit Fahrenheit/Celsius
Long press three buttons
4. Forced defrosting
When the outer coil pipe temperature is below the Exit Defrosting Temperature, press two buttons
3 seconds to enter the Forced Defrosting.
5. Change Set Temperatures:
Set temperatures can be adjusted by pressing Up
6. Status Query
To enter the unit status query, press
below.
Query code
* AP = Standalone; ** BP = Integrated with Balboa BP Spa Controller
7. Change Unit operation mode
Long press two buttons
A16: = 0 heat pump operates in AP mode; A16 = 1: heat pump operates in BP mode.
5.4. Query and setting of the system parameters
button
Query: Press
one parameter to another. Press
query.
Modify: To modify the parameter, a password will be needed. The password is 68. Follow the below procedure:

Long press

Press
+ +
Meaning
A01 Inlet water temp.
A02 Outlet water temp.
A03 Ambient temp.
A04 Exhaust temp.
A05 Return gas temp.
A06 Outer coil temp.
A08 Electronic expansion valve
opening degree
A10 Compressor current
A11 Heat-sink temperature
A12 DC bus voltage value
A13 Actual compressor speed
A14 Total main board current
A15 DC fan speed
A16 Unit operation mode
and
for 3 seconds to enter the parameter query state. Press
button
to view the value of the parameter. Press
and button to enter the input password interface,
button to enter the first password digit "6" by pressing
at the same time to switch the display of Fahrenheit and Celsius.
Down
or
button
for 3 seconds to view the temperature parameters. See table
Status Query Table
Display the range
-30~99℃
-30~99℃
-30~99℃
0~125℃
-30~99℃
-30~99℃
0~480
0~1590
0：AP* mode/1: BP** mode
for 15 seconds at the same time to switch between AP and BP modes;
buttons.
or button to switch from
button to return and exit the
or buttons,
+ for
14