Garmin GTR 205 Pilot's Manual page 5

NOTE
Canadian installations: In accordance with Canadian Radio Specifications Standard 102
(RSS 102), RF field strength exposure to persons from an antenna connected to this
device should be limited to 51 V/m for controlled environment and 22 V/m for
uncontrolled environment.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.)
is not more than that necessary for successful communication.
NOTE
The pilot/operator must review and be familiar with Garmin's database exclusions list,
as discussed in SAIB CE-14-04, to determine what data may be incomplete.
Visit flyGarmin.com
NOTE
The pilot/operator must have access to Garmin and Jeppesen database alerts and
consider their impact on the intended aircraft operation. To view these alerts,
visit flyGarmin.com
NOTE
Contact Garmin Product Support if you want or need to adjust the database.
NOTE
Garmin requests the flight crew report any observed discrepancies related to database
information. These discrepancies could come in the form of any displayed item used for
navigation or communication in the air or on the ground. Visit
"Aviation Data Error Report."
NOTE
This unit has a very high degree of functional integrity. However, the pilot must realize
that providing monitoring and/or self-test capability for all conceivable system failures is
not practical. Although unlikely, it may be possible for erroneous operation to occur
without fault indication. It is the responsibility of the pilot to detect such occurrences by
cross-checking with all redundant or correlated information available in the cockpit.
190-02766-02 Rev. A
and select "Database Exclusions List."
and select "Aviation Database Alerts."
Pilot's Guide
Warnings, Cautions & Notes
flyGarmin.com and select
iii