Table of Contents
Advertisement
3.6.3
NB Configuration
NB Configuration function varies based on the CPU installed.
Primary Video Device
Selects the primary display device. Configuration options: [IGFX Video] [PCIE Video]
3.6.4
SATA Configuration
While entering Setup, the BIOS automatically detects the presence of SATA devices. The
SATA Port items show Empty if no SATA device is installed to the corresponding SATA port.
SATA Port Enable
This item allows you to enable or disable the SATA Device. Configuration options: [Disabled]
[Enabled]
SATA Mode
This item allows you to set the SATA configuration.
[AHCI]
[RAID]
NVMe RAID mode
This item allows you enable or disable the NVMe RAID mode. Configuration options:
[Disabled] [Enabled]
SMART Self Test
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitoring system that
shows a warning message during POST (Power-on Self Test) when an error occurs in the
hard disks. Configuration options: [On] [Off]
SATA6G_1~6 (Gray), M.2_1 (Gray), M.2_2 (Gray)
Select one item and click Enter to assign a new name for the item.
Hot Plug
These items allow you to enable/disable SATA Hot Plug Support. Configuration options:
[Disabled] [Enabled]
Chapter 3: BIOS Setup
Set to [AHCI] when you want the SATA hard disk drives to use the
AHCI (Advanced Host Controller Interface). The AHCI allows the
onboard storage driver to enable advanced Serial ATA features that
increases storage performance on random workloads by allowing
the drive to internally optimize the order of commands.
Set to [RAID] when you want to create a RAID configuration from
the SATA hard disk drives.
3-14
Advertisement
Table of Contents
