Automatic Switch-Off; Cleaning; Self-Cleaning Function - Silvercrest 312063 Operating Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

Automatic switch-off

This steam iron is fitted with an automatic switch-off system . This stops the iron
from heating up .
If the iron is resting on the sole of the iron q and is not moved for about
30 seconds, you will hear a warning beep and the control lamp for the
automatic switch-off 6 will flash . The iron will stop heating up . To deactivate
the automatic switch-off, lift up the iron and move it gently from side to side . The
control lamp for the automatic switch-off 6 goes out and the iron will heat up
again .
If the iron is on its base 0 and is not moved for about 8 minutes, there will be a
warning beep and the control lamp for the automatic switch-off 6 flashes . The iron
will stop heating up . To deactivate the automatic switch-off, lift up the iron and
move it gently from side to side . The control lamp for the automatic switch-off 6
goes out and the iron will heat up again .
NOTE
The automatic switch-off is not intended as a substitute for removing the
plug from the mains power! This is merely intended to reduce the fire hazard
if you forget to switch off the iron!

Cleaning

Self-cleaning function

1) Fill the water tank to the "MAX" marking .
2) Insert the plug into the mains power socket .
3) Move the temperature control 8 to the "MAX" position .
4) Set the steam control 3 to maximum steam power .
5) Allow the steam iron to heat up until the temperature control lamp 7 goes out
and then lights up again .
6) Hold the steam iron horizontally over a suitable container .
7) Press the self-clean button w and keep it pressed . Move the steam iron back
and forth a little . Steam and boiling water will flow from the steam exit holes in
the sole of the iron q . Any impurities that may be present are flushed out .
8) Release the self-clean button w as soon as all of the water in the water tank is
used up .
9) Dry the sole of the iron q thoroughly . To do this, move the sole of the iron q
back and forth several times over a towel or an old piece of material .
10) Allow the steam iron to cool down before placing it in storage .
10 
GB │ IE │ NI │ CY
SDB 2400 F4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sdb 2400 f4

Table of Contents