Iot Gateway Interfaces; Precaution About The Iot Gateway Wireless Communication - JUKI JGW-01 Instruction Manual

Table of Contents

Advertisement

1-3. IoT Gateway interfaces

The IoT Gateway has four interfaces such as the power supply jack, serial communication connec-
tor, main shaft rotation sensor connector and switch connector.
・ Power supply jack: Connect the DC power supply for the IoT Gateway to this jack.
・ Serial communication connector: Connect the serial communication connector of the JUKI sew-
ing machine that supports serial communications to this connector.
・ Main shaft rotation sensor connector: Connect the main shaft rotation sensor to this connector in
the case the serial communication connector is not used.
・ Switch connector: Connect the production switch to this connector if necessary.
IoT Gateway
Fig. 1: Configuration of interface connectors of the main body of the IoT Gateway

1-4. Precaution about the IoT Gateway wireless communication

The IoT Gateway incorporates a WLAN module to emit and receive radio waves through an anten-
na mounted on the PCB. It implements WLAN communication by using 2.4 GHz frequency band
that conforms to the wireless communication standards IEEE 802.11b/11g/11n. Do not use the IoT
Gateway at a location adjacent to a TV or radio if it causes a receiving failure or has an adverse
effect on any other electronic equipment.
・ Precaution about the FCC (Federal Communications Commission)
FCC compliance statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two condi-
tions:(1)This device may not cause harmful interference, and (2)this device must accept any inter-
ference received, including interference that may cause undesired operation.
– 3 –
Power supply jack
Serial communication
connector
Main shaft rotation sensor
connector
Switch connector

Advertisement

Table of Contents
loading

Table of Contents