JUKI JGW-01 Instruction Manual page 13

* It is possible to set all of the IoT Gateway units with the <Method 1>. However, it will take
time if you use a large number of IoT Gateway units. In such a case, <Method 2> is recom-
mended for the sake of convenience.
<Method 2> Method to copy the settings of the host IoT Gateway to other IoT Gateway units
by using the first unit of the IoT Gateway as a host
Setting procedure
1. Set the first unit of the IoT Gateway using the <Method 1>. Check to make sure that this IoT
Gateway is connected to the access point.
First unit of the
IoT Gateway
Check to be sure that the LED indicators (POWER and SYSTEM) of the first unit of the IoT
Gateway do not blink but light up.
2. Shift the mode of the first unit of the IoT Gateway into the "maintenance mode". Turn ON the
power to the IoT Gateway. At that time, set the "overwrite settings when propagating" check
box on the Setting screen to "ON" through the web browser.
Refer to "6. Maintenance mode" for the setting procedure.
Next, press the "submit" button.
On the next screen, do not press the "restart now" button, but press the "back" button to
return to the previous screen. Keeping the screen in that state, proceed to "3".
Access point
– 11 –
MQTT broker