JUKI JGW-01 Instruction Manual page 14

3. Place the second unit of the IoT Gateway near the first unit and turn ON the power of the former.
Then, the configuration information of the first unit of the IoT Gateway is automatically copied to
the second unit. When the second unit creates a connection with the access point and successfully
sends the setting data to the MQTT broker, the LED indicators change their statuses from blinking to
lighting to indicate that the setting of the second unit of the IoT Gateway has been completed.
First unit of the
IoT Gateway
① Turn ON the second
IoT Gateway.
4. Turn OFF the second unit of the IoT Gateway.
5. Carry out setting of the third and subsequent units of the IoT Gateway in the same way.
The number of the IoT Gateway units that can be simultaneously connected to the
IoT Gateway access point is four at the maximum. Consequently, for the second and
subsequent units of the IoT Gateway, turn OFF the power to the unit immediately after
the completion of setting one after another.
② Copy the
configuration
③ Communication
information
starts after the
IoT Gateway is
connected to the
access point.
Access point
Operations ② and ③ are
automatically carried out only
by turning ON ① the second
unit of the IoT Gateway.
– 12 –
MQTT broker