Advertisement
Adjusting Solenoid Position
When a solenoid is replaced, its mounting position must be
adjusted correctly.
1)
Mount
the
solenoid
(L2)
on
the
mechanical
chassis (801). Put calipers through the rectangular
hole at the lower side of the mechanical
chassis
(801). Adjust the position of the solenoid (L2) from
under
the mechanical
chassis
(801)
so that the
distance of the iron core is 18.5£0.1mm.
Secure the solenoid and check its position. Then,
tighten and lock the screw (68).
Mechanical chassis (801)
Screw (2.6 x 4) (68)
Motor T fitting (11)
Flywheel ass''y (R.H.) with gear mounted (9A)
Motor mounting spacer (82)
Fig. 35
Replacing Main Motor Ass'y and Belt
1. Replacing Main Motor assy
1)
Remove the belt (3) and loosen one motor retaining
screw (64).
Remove
the retaining two screws
by turning the
main motor ass'y (1A) counterclockwise.
2. Replacing Belt
1)
Loosen four motor T fitting retaining screws (71).
Also, remove the belt (3).
2)
In removing
the motor T fitting (11), be careful
not to omit the flywheel
bearing
(10) and plain
washer (76).
7
Screw (2.6 x 12) (71)
Main motor
ass'y (1A)
Plain washer (76)
Belt (3)
Flywheel ass'y (L.H.)
Wide
=
Narrow
13
Advertisement
