Advertisement
REPLACING AND ADJUSTING MAJOR PARTS
Replacing Head
During assembly,
be sure to pass the head
lead wire
Loosen the two head retaining screws (65). Remove the
through
the motor cushion
(13). A different head lead
combination head (4) as seen in Fig. 32. Remove the head
wire is used according to the had employed.
Solder it as
lead wire.
shown in Fig. 31.
Note:
Fix the UL tube with adhesive agent.
Wires marked with ''C___1]"" should
not be routed through the motor
cushion (13),
Combination head (4)
—
Screw
Playback on KX-94W (Deck A)
Motor cushion (13)
| (Tape guide)
yy
(61.4 x 6) (65)
Fig. 32
WHT + 1] | CRED
BLK
-E_]
Co+-BLU
A
iw,
|
L236)
Tape guide (36)
Recording, Playback,
Erase on KX-94W (Deck B)
Fig, 31
Adjusting nut
(L.H.) (35)
————————————s
es
Azimuth adjusting
screw (L.H.)
1)
Align the adjusting
nuts
(35) on the right-hand
and left-hand tape guides (36) to the upper end of
shaft as shown in Fig. 33-A.
2)
Play back a 6.3kHz or 10kHz test tape in forward
play mode, turn the R.H. azimuth adjusting screw
for adjustment. (See Fig. 33.) Then, play back the
Fig. 33
test tape in reverse play mode and turn the L.H.
azimuth
adjusting screw for adjustment
(See Fig.
34.)
3)
Using the mirror tape, check that the tape runs
normally
in forward
and reverse play modes and
that the tape is not curled at the tape guide on the
combination head (4).
4)
\f the tape is found to be curled, turn the adjusting
nuts (35) on the R.H. and L.H. tape guides (36)
to adjust the tape.
5)
Repeat steps 2) and 3) above.
6)
When running of the tape has been adjusted, tighten
and
lock
the
adjusting
nuts
(35)
and
azimuth
adjusting screws.
12
Advertisement
