Simulated Stereo - Pioneer VSX-5700S Operating Instructions Manual

SIMULATED STEREO
This function transforms monaural signals into simulated stereo sound.
Use it when you wish to experience a sense of stereo presence when
listening to AM broadcasts, or VCR and other monaurai signal sources.
NOTE:
* The simulated stereo function can also be used with stereo sound
sources, but it will result in an effect somewhat different from the
normal stereo sound. ,
*© With a monaural source, switch the SURROUND MODE to the
SIMULATED SURROUND pesition. In any other position (STADIUM,
DOLBY SURROUND), there will be no effect.
CONNECTIONS
Setting Up the AM Antenna
* Insert the claw on the bottom of the antenna into the hole in the leg.
* Place the antenna on a level surface and rotate it to locate the
orientation that yields the best reception.
* Use the attachment hole in the leg to screw to wail or other location,
then insert the claw on the bottom of the antenna into the hole in
the leg {fixing the antenna in the direction that gives the best
reception).
Precaution regarding installation position of cassette deck. i
If the cassette tape deck is instailed in the ® positions shown in
the drawing below, hum may occur during playback.
if there is any hum, move the unit away to a position where the hum
goes away.
®
7
<ARB1250>