Table of Contents
Advertisement
CD-P1100 |
1 SPECIFICATIONS
Pickup: 3- beam, semiconductor laser
Encoding: 16 - bit linear
Frequency Response: 5 — 20,000 Hz + 1 dB
Total Harmonic Distortion:
< 0.03 % (1 kHz)
Signal to Noise Ratio:
> 100 dB
Channel Separation:
> 85 dB (1 kHz)
Wow and Flutter: Below measurable limit
Power Requirements:
120 V AC, 60 Hz (U.S.A. Model)
230 V AC, 50 Hz (U.K./Europe Model)
120/230 V AC, 50 — 60 Hz
(General Export Model)
240 V AC, 50 Hz (Australia Model)
Power Consumption: 15 watts
Dimensions (WxHxD):
435 x 80 x 280mm
(17-1/8" x 3-1/8" x 11")
Welght (net): 4.0 kg
@ Improvements may result in specification or feature
changes without notice.
VOLTAGE CONVERSION
(For general export models)
Be sure to remove
the power
cord from the AC outlet
before repositioning the voltage converter switch.
1. Locate the voltage selector on the rear panel.
2. Using a flat- bladed screwdriver, set to the appropriate
230 V or 120 V position according to your area.
VOLTAGE
SELECTOR
120
g 230
SAFETY INFORMATION
This product has been designed and manufactured according to
FDA regulations "title 21, CFR, chapter 1, subchapter J, based
on the Radiation Control for Health and Safety Act of 1968 ",
and
is
classified
as
class
1 laser
product.
There
is not
hazardous
invisible
laser radiation
during operation
because
invisible
laser
radiation
emitted
inside
of this
product
is
completely confined in the protective housings.
The label required in this regulation is shown (1).
CAUTION
USE OF CONTROLS
OR ADJUSTMENT
OR PERFORMANCE
OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN
MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
Optical pickup:
Type : SF-91P
Manufacturer : SANYO Electric CO., Ltd.
Laser output
: Less than 0.5 mW on the objective lens
Wavelength
:765 — 815 nm
®D
CERTIFICATION
THIS PRODUCT COMPLIES WITH DHHS
RULES 21 CFR SUBCHAPTER J APPLI-
CABLE AT DATE OF MANUFACTURE
That. ct
TON
21 DNAKA-CHO MUBASHIND BER TOKYO JAPAN
MANUFACTURED
id
Advertisement
Table of Contents
