Ending The Measurement; Reading Out Data; Connecting With The Software Application; Figure 10 Usb Type- A Connection - G-Tek LM Pro T051 Operating Manual

Tag Id Tag Event
A1 Alarm1 Triggered
B1 Alarm1 Reset
A2 Alarm2 Triggered
B2 Alarm2 Reset
A3 Alarm3 Triggered
B3 Alarm3 Reset
A4 Alarm4 Triggered
B4 Alarm4 Reset
TAG Manual Tag
Note: Number of data records get reduced according to number of Tag data events. Tag
Event(s) can be seen in software application and generated pdf report after downloading
data.

5.7.3 Ending the Measurement

➢ The measurement program is ended by one of three ways:
1. As per the preconfigured batch stop time, the measurement will be stopped.
2. If batch stop time is not set during the batch configuration, the measurement will
be stopped, once the maximum no. of readings has reached.
3. By connecting the device with the LMViewE051 application, using "Stop" option.
➢ Once the measurement stops, "REC" message disappears from the device display, RUN
LED turns Off and STP LED starts flashing.

5.8 Reading out Data

5.8.1 Connecting with the Software Application

Displaying a measurement data report
➢ Connect the LM
Pro
in figure 10.
➢ After connecting the data logger with PC, display remains ON along with the other values.
Page 17
Description
Alarm1 high/low condition has occurred.
Alarm1 high/low condition is restored.
Alarm2 high/low condition has occurred.
Alarm2 high/low condition is restored.
Alarm3 high/low condition has occurred.
Alarm3 high/low condition is restored.
Alarm4 high/low condition has occurred.
Alarm4 high/low condition is restored.
User has entered a tag from device.
T051 data logger with Windows PC via the USB Type-A port, as shown

Figure 10 USB Type- A connection