Configure Multiple Devices; Figure 6 Set Up Batch On Multiple Devices - G-Tek LM Pro T051 Operating Manual

8. Start Time: It is the time at which Batch will start in the device. User can preset the
batch start time by selecting the date and time as per required batch start delay. The
first data is stored at the batch start time.
9. Stop Time: It is the time at which the data logging will be stopped in the device. User
can set the stop time, if required otherwise it will be calculated based on the start time
and store interval as per maximum number of readings.
10. Display Options:
a) Display Auto Off (default) - This option is normally selected to save battery life of
the data logger
b) Display Permanent On - This option will reduce the battery life of the data logger
After setting the batch parameters, press "Configure Batch" button to configure the batch for
the device.

5.2 Configure Multiple Devices

If multiple devices are to be configured with the same parameters, user should select the
multiple batch configuration option in the software application.
➢ Follow the steps as per section 5.1.1 and 5.1.2 for the alarm and batch configuration for
first device.
➢ Select the suitable start time of the batch so that multiple devices can be configured and
started at the same start time.
➢ After configuring the first device, message window will be pop up as shown in figure 6.
Connect another device to the PC application, click on "OK" button to proceed further.
➢ The user can update the ID and Batch name for the other devices, remaining parameters
in the batch configuration remains same.
➢ Once the configuring multiple devices is finished, click on "Cancel" button and exit from
the configuration setup.
Page 13

Figure 6 Set up Batch on Multiple devices