Table of Contents
Advertisement
4-1. Serial Number And Rating Label Location
The serial number and rating information for this product is located on the rear panel. Use rating label to determine input power requirements and/or
rated output. For future reference, write serial number in space provided on back cover of this manual.
4-2. Software Licensing Agreement
The End User License Agreement and any third-party notices and terms and conditions pertaining to third-party software can be found at
https://www.millerwelds.com/eula
4-3. Information About Default Weld Parameters And Settings
NOTICE − Each welding application is unique. Although certain Miller Electric products are designed to determine and default to certain typical welding
parameters and settings based upon specific and relatively limited application variables input by the end user, such default settings are for reference
purposes only; and final weld results can be affected by other variables and application-specific circumstances. The appropriateness of all parameters
and settings should be evaluated and modified by the end user as necessary based upon application-specific requirements. The end user is solely
responsible for selection and coordination of appropriate equipment, adoption or adjustment of default weld parameters and settings, and ultimate
quality and durability of all resultant welds. Miller Electric expressly disclaims any and all implied warranties including any implied warranty of fitness
for a particular purpose.
4-4. Unit Specifications
Type of Input Power
24 Volts AC
Constant Voltage (CV)
Single-Phase
DC With 14-Pin And
50/60 Hertz
* See Section 5-5 for detailed information on wire type, wire size, and wire feed speed.
4-5. Environmental Specifications
A. IP Rating
This equipment is designed for indoor use and is not intended to be used or stored outside.
B. Temperature Specifications
Operating Temperature Range
14 to 104°F (−10 to 40°C)
C. Information On Electromagnetic Fields (EMF)
!
This equipment shall not be used by the general public as the EMF limits for the general public might be exceeded during welding.
This equipment is built in accordance with EN 60974−1 and is intended to be used only in an occupational environment (where the general public
access is prohibited or regulated in such a way as to be similar to occupational use) by an expert or an instructed person.
Wire feeders and ancillary equipment (such as torches, liquid cooling systems and arc striking and stabilizing devices) as part of the welding
circuit may not be a major contributor to the EMF. See the Owner's Manuals for all components of the welding circuit for additional EMF exposure
information.
S
The EMF assessment on this equipment was conducted at 0.5 meter.
S
At a distance of 1 meter the EMF exposure values were less than 20% of the permissible values.
D. Information On Electromagnetic Compatibility (EMC)
!
This Class A equipment is not intended for use in residential locations where the electrical power is provided by the public low−
voltage supply system. There can be potential difficulties in ensuring electromagnetic compatibility in those locations, due to con-
ducted as well as radiated disturbances.
OM-273243 Page 12
SECTION 4 − SPECIFICATIONS
and are incorporated by reference herein.
Welding Power
Wire Feed Speed
Source Type
50 To 780 ipm
Contactor Control
(1.3 To 19.8 mpm)
Overall Dimensions
Standard:
Length: 17 in. (432 mm)
Width: 8.5 in. (216 mm)
Height: 12 in. (305 mm)
IP Rating
IP2X
Storage/Transportation Temperature Range
−4 to 131°F (−20 to 55°C)
Weight
30 lb
(13.6 kg)
IP2X 2014−06
Temp1_016- 08
ce-emf 1 2010-10
ce-emc 3 2014-07
Advertisement
Table of Contents
Troubleshooting
