Juicing; Cleaning - Silvercrest SZP 25 C3 Short Manual

Juicing

ATTENTION! PROPERTY DAMAGE!
Stop the juicing process immediately if the pressing cone 2/3 is labouring
►
or does not turn at all. Pull out the plug and check the appliance for
jammed fruit pulp or foreign bodies.
► Make sure that you do not block or overload the motor. Do not press down
excessively hard on the pressing cone 2/3.
The appliance has been cleaned and assembled:
Use the selector switch 6 to set the pulp content of the juice on a scale from
fine (small pieces) to coarse (larger pieces).
Remove the lid 1 if necessary.
Press the citrus fruit halves with the flat side downwards onto the pressing
cone 2/3 and apply a light pressure. The pressing cone 2/3 starts to
rotate and the citrus fruit is squeezed out.
To stop the appliance, lift the citrus fruit half from the pressing cone 2/3.
NOTE
Start and stop the appliance several times. The pressing cone 2/3 changes
►
direction when the appliance is started and stopped repeatedly, which
leads to a better juice yield.
Empty the juice container 7 as soon as it reaches the 800 ml mark. To do
this, pull out the mains plug, turn the juice container 7 anticlockwise and
lift it off the base q.
Clean the appliance as soon as possible so that the fruit pulp does not dry
on and make cleaning the appliance more difficult.

Cleaning

RISK OF ELECTRICAL SHOCK!
► Before cleaning the appliance, pull out the plug from the mains power socket.
►
ATTENTION! PROPERTY DAMAGE!
► Do not use aggressive or abrasive cleaners, as these may damage the
surface of the appliance.
Clean the lid 1, the pressing cone 2/3, the sieve attachment 4/5, the
juice container 7 and the cover of the drive shaft 9 in a mild soap solution.
│ GB │ IE
■ 8
Never clean the base q, the mains cable and plug under running
water and never immerse these parts in water or any other liquids.
SZP 25 C3