UTStarcom F1000 User Manual page 60

Menu -> WiFi-Settings
If WPA-PSK is selected, the phone will then display the PSK-editing
screen (refer to "WPA-PSK Info")
WEP Key Info
If the AP profile's security mode is set to WEP Key, select this option to
set the WEP key. After accessing this option, observe the following
operations:
1. Select Auth. Method, and then select the authentication method:
Open Key or Shared Key.
2. Select 64bit or 128bit according to the AP's WEP key setting. Enter
the WEP key that the AP used, and press the left soft key
- If 64bit is selected, ensure that the WEP key consists of five ASCII
characters or ten hexadecimal characters
- If 128bit is selected, ensure that the WEP key consists of 13 ASCII
characters or 26 hexadecimal characters
3. Select WEP Key Index. Enter the WEP key index (1-4), and then
press the left soft key
Note: The WEP key setting may be different due to AP settings.
If an AP supports only a fixed hexadecimal WEP key, you should
enter the same WEP key in the phone.
If an AP supports both ASCII and hexadecimal WEP keys, you can
enter either the ACSII WEP key or the hexadecimal WEP key in the
phone.
WPA-PSK Info
If the AP profile's security mode is set to WPA-PSK, select this option to
set the WPA-PSK key.
After accessing this option, enter the WPA-PSK key and press the left soft
key (Ok) to complete the operation.
56
(Ok).
(Ok).