Table of Contents
Advertisement
Q.2
Getting Your Device Ready
Install and charge the battery
New batteries are shipped partially charged. Before you can use your Pocket PC Phone,
you need to install and charge the battery. To install the battery, remove the battery cover
first, and then insert the battery by aligning the exposed copper part of the battery pack with
the protruding copper conductor. Then, gently push the battery into place, and replace the
battery cover.
Some batteries perform best after several full charge/discharge cycles. The time needed to
fully charge the battery is less than 4 hours. You can charge the battery by:
•
Connecting your device directly to the electrical outlet via the AC Adapter.
•
Plugging the device sync cable into the USB port on your PC.
•
You can also charge the battery using the USB cradle (connecting to the electrical
outlet or your PC).
When your device is turned off, charging is indicated by a solid amber light on the LED
indicator. When your device is turned on, charging is indicated by a solid amber light on
the LED indicator as well as a charging icon (
the LED indicator or a charged icon (
complete.
When the battery power gets very low, your device screen displays a warning message.
When you see this, immediately save your data by synchronizing with your PC, or save your
data on a secondary storage card, and then turn off your device. Do not try to restart your
device until you have connected your device to an external power supply.
Turn on your device
Press POWER to turn on your device. When you turn on the device for the first time, you are
asked to complete a screen calibration process.
To turn off the device, press POWER again.
|
6
) on the device screen. A green light on
) on the device screen indicates that charging is
Advertisement
Table of Contents
Need help?
Do you have a question about the PPC-6700 and is the answer not in the manual?
Questions and answers