Magiqcool Controller Settings; Manual Mode; Auto Mode; Magiqcool Controller Operation - Seeley Breezeair EXQ Owner's Manual

MAGIQCOOL CONTROLLER
SETTINGS
MagIQcool Wall Controllers can operate in
manual or automatic mode.

Manual mode

Manual mode will allow you to change settings
for operating the cooler, such as altering
fan speeds, pump control and manual drain
control.

Auto mode

Auto mode will allow thermostatic control to set
temperature targets / operating settings. It has
the capability of programming ON/OFF delay
times, enabling the cooler to automatically
start up or shut down after a specified period
of hours.
At all times the MagIQcool Controller will
monitor the cooler for faults and report them to
the controller's screen for your reference.
|
2
MAGIQCOOL CONTROLLER
OPERATION

Turning the Cooler On

The wall control can be switched on and off by
pressing the button. The wall control
will remember the previous setting it was in
when the cooler was last used.

Preparing to Start

Whenever you select AUTO mode or COOL
in MANUAL mode, the cooler will take a
few minutes to start as it fills with water and
saturates the cooling pads. The time will be
decreased if the tank is full or the cooler has
only recently been turned OFF.
During this time "Preparing to Start" will flash
on the display.
Manual Mode
With the wall control switched ON,
press the button until MAN is shown
on the display.
ILL2121-A
ILL1122-A