Water Management; Watermiser; Drain Valve; Bleed System - Seeley Breezeair EXQ Owner's Manual

WATER MANAGEMENT

Your evaporative cooler will be fitted with either
a WaterMiser system, or a continuous bleed
®
system. Check with your dealer to determine
which system has been installed.

WATERMISER

®
Breezair evaporative coolers are fitted with
®
the WaterMiser feature which automatically
®
monitors the quality of the water in the cooler.
The WaterMiser drains the existing water in
®
the cooler to allow it to be replaced with fresh
water, only when it is needed. Therefore,
you may notice your cooler draining water
occasionally. How often the WaterMiser
performs this operation depends upon the
quality of the water supply and the rate of
evaporation. In areas of poor water quality, the
WaterMiser will operate more often as it tries
®
to maintain the optimum water quality in the
cooler. This maximises the cooling effect and
life of the cooling pads.
The WaterMiser allows you to specify either
®
high or low salinity settings. The low salinity
setting is used in specific circumstances only.
We recommend talking with your dealer before
adjusting this setting.
The high salinity setting is designed to operate
the cooler at a maximum safe salinity level to
maintain a normal working life. It also results in
a minimum usage of water.
Note! High salinity outlet water can be used on
saline tolerant gardens, but should not be used
on salt sensitive grasses or plants.
The factory default WaterMiser
HI. For areas operating with bore water,
WaterMiser should be switched to off.
®
This will disable the salinity measuring circuit
and simply drain water from the tank every
65 minutes of operation.

DRAIN VALVE

If your cooler has been installed with a drain
valve, it is accompanied by the WaterMiser
salinity probes. When the tank's water salinity
level reaches a preset level the WaterMiser
|
6
open the drain valve and release saline water.
Fresh water will then be added diluting any
minerals or salts accumulated. The WaterMiser
will continue to monitor and drain water as
required.
Alternatively, the cooler can be set to drain
saline water at a preset period of pump
operating time. This can be set by changing
the salinity control method selector via the
cooler settings screens.
Note! When the cooler's tank is empty and the
cooler is turned on again, the fan operation will
be delayed as the tank is refilled and the pads
are saturated.
®

BLEED SYSTEM

If fitted, the bleed system will constantly drain
small amounts of water during the operation of
the cooler. This allows fresh water to be added
diluting any minerals and salts accumulated.
The bleed rate for your cooler will depend
on local operating conditions and will be
set by the installer.

POWER OUTAGES

After a power outage the MagIQtouch Controller
will prompt you to enter the date and time.
If the AUTO RESTART option is switched on in
the SETTINGS menu, the following actions will
result:
• If the cooler was last running in MANUAL
setting is
®
• If the cooler was last running in PROGRAM

HEALTH REGULATIONS

In some regions, regulations require that
®
evaporative air coolers be serviced at specific
intervals.
will
®
mode, it will automatically restart only after
the date and time have been confirmed.
mode, it will automatically restart, even before
the time and date have been set, according
to the last time recorded before the power
outage.
®