Table of Contents
Advertisement
CONTROL SCHEMES
CONNECTING THE MAGIQTOUCH / MAGIQCOOL
CONTROLLER
®
Refer to the installation manual provided with the MagIQtouch
Controller for instructions on installing the controller. The wall
control cable plugs into the electronics module - (A) (refer
diagram adjacent). Coolers are supplied with a 20m (66')
control cable. Longer cable lengths are available from Seeley.
Important! The maximum cable length allowed from the
MagIQtouch Controller to the first cooler is 20 metres (66'). For
any additional coolers added into the system with a link module
the maximum allowed length is 40 metres (131'). Therefore,
failure of the product or components to operate correctly due
to modification to supplied cables, or the use of non-approved
cables will NOT be accepted under the Manufacturer's
Warranty.
We have this cable available through our Sales order office and
spare parts outlets in the following lengths:
Part No. Length Details
833880
20m
MagIQtouch Controller Cable (No Ferrite)
823553
20m
MagIQtouch Controller Cable EXQ/EXS (With Ferrite)
862873
1.5m
MagIQtouch Controller Cable (No Ferrite)
861265
3m
MagIQtouch Controller Cable (No Ferrite)
864396
30m
MagIQtouch Controller Cable EXQ/EXS (With Ferrite)
864402
40m
MagIQtouch Controller Cable EXQ/EXS (With Ferrite)
MAGIQTOUCH CONTROLLER
Diagnosis and cooler operating information can be viewed from
the MagIQtouch Controller. Faults are displayed on the screen
as they occur.
Cooler operating information is available from the 'Service
Operating Screen' under the COOLER tab of the SETTINGS
menu.
OPERATION
®
ILL1714-A
ILL1664-A
For individual, direct control installations, Climate Wizard CW-
6S coolers are supplied from the factory with:
a)
MagIQtouch Control Kit and 20m (65') control cable,
and as an option
b)
MagIQtouch MS1 BMS Industrial Controller
OPTION - MS1 BMS
INDUSTRIAL CONTROL
The MagIQtouch Controller and the M1 BMS Industrial
Controller are both compatible for use with the Climate Wizard
CW-6S cooler.
These make it possible for the cooler to be controlled
independently and automatically from the zone to which it is
delivering cool air. The MagIQtouch incorporates a thermostat
that regulates fan speed to maintain indoor temperature
within +0.5°C (+ 1°F) of the set temperature. Climate Wizard
coolers are also supplied with input/output connectors via a
MagIQtouch MS1 BMS Interface module to enable the cooler to
be controlled from an external location, using a modbus BMS
system.
Whichever control option is being used, the inbuilt Climate
Wizard water management and fault monitoring features
are always functional. The Climate Wizard control scheme
incorporates some parameters which can be altered to other
settings if the default settings are not suitable.
BUILDING MANAGEMENT SYSTEM (BMS)
INTERFACE (OPTIONAL)
Refer to the Installation & Operation Manual for MagIQtouch
MS1 BMS Industrial Controller, included with the cooler.
This can be set up to control the Climate Wizard from
EXTERNAL devices, such as PLCs and Building Management
Systems.
Note! Even if a BMS is used, it is suggested that technicians
obtain a MagIQtouch Wall Controller as a tool for use during
servicing. The MagIQtouch Controller provides additional user
and technician functions.
CW-6S INDIRECT COOLER INSTALLATION MANUAL | 25
ILL2792-A
Advertisement
Table of Contents
