LG ARNU363DDA4 Installation Manual page 14

UNIT INSTALLATION
Step 12�
Remove the mixed-air temperature sensor from its shipping loca-
tion. This is located in the outside air intake hood behind the water
entrainment filters next to the damper actuator.
Step 13�
Route the mixed-air sensor wires through the LG Split RTU to the
supply blower compartment.
Step 14�
Mount the mixed-air sensor on the supply blower so the end of the
sensor is over the inlet of the supply blower.
14
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Figure 19: Mixed Air Sensor.
Figure 20: Routing the Mixed-Sensor Wires to the Supply Blower Com-
partment.
Figure 21: Mixed-Air Sensor Over the Supply Blower Inlet.