Hisense HRM260N6TSE User's Operation Manual page 7

Adjusting Door Height And
Door Gap
The height of a door can be adjusted using
the provided Snap Rings. Tools you will
need:
Snap Ring (4pcs)
To Adjust The Height Of Door
1.Check the height difference between the
doors and then lift and hold the lowest
door to be even with the other.
2.Insert a suitably sized Snap Ring between
the Door and the Hinge as shown.
Important
1.Insert only one Snap Ring. If you insert
two or more Snap Rings, they may slip out
or cause a rubbing noise.
2.Do not raise the door too much.
The door may contact and damage the
top cover.
3.Save remaining Snap Rings for possible
future use.
Warning
Contains Small Parts, Keep the Snap Rings
Away From Babies and Children
Wrench(Not provided)
Leveling of appliance
For sufficient leveling and air circulating
in the lower rear section of the
appliance, the bottom feet may need to
be adjusted. You can adjust them
manually by hand or by using a suitable
tool.
To allow the doors to self-close, tilt the
top backwards by 0.4" - 0.6"(10 -15mm).
0.4" - 0.6" (10-15mm)
Adjustable
A
bottom feet
Front roller
B
Rear roller
C
A B C
Adjustable
bottom feet
7