Hisense HRM260N6TSE User's Operation Manual page 10

13 . Take out the lower drawer.
14 . Take out the freezer door.
15 . Move your refrigerator into its final
position, then re-install the drawers and
doors by reversing these steps.
Warning
In order to ensure the self-close
mechanism works correctly, please make
sure the doors are opened more than 90
degrees when you remove or reattaching
them.
Installing the water lines
Ice & water dispenser with a filter is one
of the helpful features on your new
appliance. To help promote better
health, the water filter removes
unwanted particles from your water.
Please follow the below instructions
carefully for correct installation.
In order for the ice & water dispenser to
operate properly, a water line is
required.
-the maximum inlet water pressure is
700kPa;
-the minimum inlet water pressure is
207kPa.
Warning
The water connection must be made by
a qualified plumber. Operation outside
the water pressure range may cause
malfunction, or severe and damaging
water leaks.
Under normal conditions, a200cc (5.75
oz.) cup can be filled in about 10 seconds.
If the refrigerator is installed in an area
with low water pressure (below 30psi),
you can install a booster pump to
compensate for the low pressure.
10