Hisense HRM260N6TSE User's Operation Manual page 12

6. Turn the water on and check for
leakage.
Connect Water Line
to Refrigerator
Important
If you turn the refrigerator on before the
water is connected, turn off the ice maker.
1. You may need to purchase below items
to complete this connection. And you
may find these items sold as a kit at a
local hardware store.
Ferrule (Sleeve) -1 pcs
a b c a
1/4" Compression Nut - 1 pcs
b
1/4" Water Line -1 pcs
c
2. Unplug refrigerator or disconnect
power.
3. Close shutoff value.
4. Thread a 1/4 " compression nut and
ferrule (sleeve) onto the free end and of
1/4" water line.
5. Insert the free and of the 1/4" water line
into the brass fitting attached to the
water inlet on the back of the refrigerator.
6. Slide the 1/4" compression nut over the
ferrule (sleeve) and screw the 1/4"
compression nut onto the brass fitting.
c
b
a
d
e
7. Comfirm 1/4" water line is secure by
gently pulling on it.
8. Turn on water supply and check for
leaks. Correct any leaks
Note
Use only the new tubing supplied with
the refrigerator. Old tubing should not
be used. After connected to the water
supply line, please open the water
valve to flush the filter for 5 minutes
before use.
The initial dark discoloration of water is
normal.
Warning
The water line must be connected to
the cold water pipe. If it is connected
to the hot water pipe, it may cause the
purifier to malfunction.
Avoid contamination of pipes during
installation.
Connect to potable water supply only.
1/4" Water Line
c
1/4" Compression Nut
b
Ferrule (Sleeve)
a
Brass Fitting
d
Water Inlet
e
12