Subscribe to Our Youtube Channel
Related Manuals for CANADA BILLARD & BOWLING INC BRIDGE
Summary of Contents for CANADA BILLARD & BOWLING INC BRIDGE
- Page 1 BRIDGE Installation manual 2020-12-30 CANADA BILLIARD & BOWLING INC. 4050 Industriel blvd, Laval, QC, H7L 6C3 450-963-5060 W W W.CANADABIL LIARD.COM...
-
Page 2: Lifetime Guarantee
LIFETIME GUARANTEE CANADA BILLIARD is pleased to offer an unsurpassed LIFETIME GUARANTEE TO THE ORIGINAL PURCHASER against defects in material and workmanship, provided installation and/or service is performed by an Authorized Dealer or a factory-approved installer. Cloth, pockets and rail cushions are not covered under this guarantee. - Page 4 1 Place the hardware on a clean surface. 2 Unwrap legs and unscrew leg levellers for about 1/2". 3 Place on the ground, on a clean surface, the 4 frame Fasten the 3/8"-16 x 3" pieces and the 3 cross pieces. threaded bolts in the long frames.
- Page 5 Loosely fasten the long cross pieces to the short 8 Fix all pieces. cross piece with the 3/8"-16 x 3 1/2" bolt, the 7/16" flat washers and the 3/8" weld nuts. 9 While raising one end of the assembled base frame, 10 Find the highest corner.
- Page 6 13 Pre-drill with a 5/32" dia. drill bit the fixing 14 Using the wedges, adjust joints so that the two slate and fix the 3 section slate in 12 points surfaces are equal. Unscrew and screw in as needed. with screws #14 2 1/2". Check the level.
- Page 7 19 Pulling toward #2, staple on #2. Repeat for #3. 20 Pulling tightly toward #1, staple approx. 4". Pulling tightly toward #4, staple approx. 4". Repeat for #2, #3 and #4. Repeat for #5 and #6. 21 Cut 5 to 6 slits on one of the center pockets. 22 Pull and staple under the slate frame.
- Page 8 25 Stretch and staple all sides. 26 Locate rail attachment holes and cut clearance Cut excess of cloth. on cloth with a sharp knife (approx. 1/2" dia). 27 Use counter bolts to 28 Place the dowels pins 5/8" x 2". Place assemble the rails.
- Page 9 31 Screw the 3/8"-16 x 3 full threaded 32 Put together the panels' frame rods into the rails. following the numeral order. 33 Assemble the frame using 1/4"-20 x 1 1/2" 34 Adjust and tighten machine screws and 5/16" flat washers. the screws.
- Page 10 37 Secure the rails with 3/8" tooth lock washers 38 Align the side rails and and 3/8"-16 hexagon nuts on threaded rods tighten all the rails. (make sure the nut is not cross-threated). 39 Nail the pockets. Make sure all the surface 40 Fasten the leather straps under the slate covers the rails.
- Page 12 YOU ARE NOW READY TO PLAY YOUR FIRST GAME OF POOL ON YOUR MAGNIFICENT BILLIARD TABLE FROM CANADA BILLIARD ! CONGRATULATIONS ! CANADA BILLIARD & BOWLING INC. 4050 Industriel blvd, Laval, QC, H7L 6C3 450-963-5060 W W W.CANADABILLIARD.COM...
Need help?
Do you have a question about the BRIDGE and is the answer not in the manual?
Questions and answers