Other Codes Description - DAYLIFF SUNVERTER 4 Installation & Operating Manual

5.3 Fault Inquiry and Reset
The Sunverter records the fault codes of the latest 4 events. Searching this information
will help find the fault cause. Fault information is stored in the control parameters
Pr.20~Pr.23 refer to the panel operation instructions to view the fault codes and find
solutions.
When a fault occurs and the inverter needs reset to return to normal, press
reset or switch off power supply.
Be sure to check the cause of fault and eliminate it before
resetting. Continuous resetting of the inverter is harmful to
the controller.
CAUTION
Allow delay of 5 minutes before reset for overload and
overheat protection
CAUTION

5.4 Other Codes Description

Important Note
Code
Code Description
User parameters initialization
Important parameter modification
All parameters initialization
Inverter Model
Model Setting Error
Start Delay Time
Return to normal after resetting
Return to normal after resetting
Return to normal after resetting
Three-phase 220V, rate power 1,500W
Single-phase 220V, rate power 1,500W
Three-phase 380V, rate power 3,000W
Set the dipswitch correclty, execute all parameters
initialization
Countdown of the restart: 30 seconds
6 29
STOP
Explanation
key to