Chapter 1 General Information; Important Information; Warning And Safety Instructions; Warranty Claims - Exclusion Of Liability - Helios AIR1-SM DX Installation And Operating Instructions Manual

Installation and Operating Instructions
CHAPTER 1
GENERAL INFOR-
MATION
m
DANGER
m
m
DANGER
m
WARNING
m
CAUTION
ATTENTION
ATTENTION
m
CAUTION
ATTENTION
Control module AIR1-SM DX
11

Important information

In order to ensure correct operation and for your own safety, please read and observe the following instructions care-
fully before proceeding. Important information and necessary cleaning and maintenance activities is specified in the
maintenance section. The cleaning and maintenance work may only be carried out by qualified electricians. The chapter
"Installation and commissioning" with important installation information and basic unit settings is intended for the spe-
cialist installer.
m
The electrical connection must be fully isolated from the mains power supply until final assembly!
This unit is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction con-
cerning use of the unit by a person responsible for their safety Children should be supervised to ensure that
they do not play with the unit
Keep the installation and operating instructions with the unit for reference. The document must be handed to the ope-
rator (tenant/owner) after final assembly.
12

Warning and safety instructions

The adjacent symbol is a safety-relevant prominent warning label All safety regulations and/or symbols must be
absolutely adhered to, so that any dangerous situation is avoided
m
DANGER
Indicates dangers which will directly result in death or serious injury if the safety instruction is not followed.
m
WARNING
Indicates dangers which will result in death or serious injury if the safety instruction is not followed.
m
CAUTION
Indicates dangers which can result in injuries if the safety instruction is not followed.
ATTENTION
Indicates dangers which can result in material damage if the safety instruction is not followed.
13 Warranty claims – Exclusion of liability
If the preceding instructions are not observed, all warranty claims shall be excluded. This also applies for liability claims
against the manufacturer.
The use of accessories, which are not recommended or offered by Helios, is not permitted. Any possible damages are
not covered by the warranty.
14 Area of application – Intended use
The control module DX is a necessary accessory for connecting the ventilation units in AIR1 series XC, XH or
RH to an on-site cooling system
The control module DX can be used with the following unit types:
-AIR1 XC500, XC700, XC1400, XC2200, XC3200
-AIR1 XH1000, XH1500, XH2500, XH3500, XH4500, XH5500, XH7000, XH8500
-AIR1 RH1500, RH2000, RH3000, RH5000, RH6000, RH8000, RH9500, RH12000, RH15000
The intended use also includes observance of the operating manual as well as the inspection and maintenance intervals
stipulated by HELIOS.
The control modul AIR1-SM DX is only suitable for indoor installation
Ambient temperature:
Humidity:
Protection class:
Any use other than the intended use is prohibited!
0° - +40°C
max. 90% RH
IP 55
2
EN