Table of Contents
Advertisement
Camera Recording
Whenever the Palmcorder has been in Record/Pause mode for 5 minutes, it will auto¬
matically go into Stand-by mode to conserve power. To resume recording, it is necessary
to turn the Palmcorder POWER switch to OFF and then to CAMERA. Or, you may use
the following feature to avoid having to turn the Palmcorder off and on again.
Stand-by Release
This feature allows you to resume record¬
ing from Stand-by mode by simply pressing
the RECORD/PAUSE button.
Before you begin...
• Connect the Palmcorder to a power source.
• Insert a cassette with record tab (see page 10).
1
While pressing the UP
A
button, set
the POWER switch to CAMERA.
Press UP
A
more than 2 seconds
to
display the STAND-BY RELEASE
selection screen.
Press UP
A
or DOWN ▼ as
necessary
to select
Q3IQ1.
Press DISPLAY
to set your selection
and exit this screen.
• You may now turn the Palmcorder
back on after it has gone into Stand¬
by mode by pressing the RECORD/
PAUSE button.
Note:
If izwjHMiWi was selected in step 3
above, you must set the POWER switch to
OFF and then to CAMERA to resume
recording from Stand-by mode.
20
Advertisement
Table of Contents
