Table of Contents
Advertisement
Supplying Power
Charge Battery Pack fully before use.
Plug in AC Adaptor.
POWER Lamp lights.
2
Insert Battery.
@ Align right side of Battery with line
on AC Adaptor.
© Press Battery down and slide in .
direction of arrow.
CHARGE Lamp lights and then goes
out when charging is done (approx.
1 and 1/2 hours).
CHARGE
Lamp
3
Remove Battery
Slide Battery out and off.
Note:
e Battery life gradually decreases after
After recharging 5 times, use BATTERY
repeated use and recharging. If operation
REFRESH
feature as explained on page 11.
time becomes very short even after a
sufficient charge, discard Battery properly
(page 11).
Use the Battery Pack
A fully charged Battery provides a maximum of about 2 hours of continuous use (LCD
monitor off) or about 1.5 hours (LCD monitor on). Actual time may vary due to operating
conditions. Using the Built-in Light decreases operating time.
1
Attach Battery
@ Align Battery with top of mounting
surface.
© Press and snap into place.
\
\
2
Remove Battery
While sliding BATTERY RELEASE,
remove Battery.
10
For assistance, call 1-800-211-PANA(7262)
Advertisement
Table of Contents
