Table of Contents
Advertisement
AC Adaptor
DC Power Cable
POWER Lamp
Supplying Power
VCR DC OUT Connector
DC IN
Connector
Connect the VCR DC OUT on
the AC Adaptor to the DC IN on
the Palmcorder with the DC
Power Cable (supplied).
Plug in the AC Adaptor.
The POWER Lamp will light up.
Note:
• AC Adaptor can not be used to power the Palmcorder while charging the Battery.
* While not in use, unplug the AC Adaptor from the AC outlet. (AC Adaptor consumes
1.2W of electric power if it is plugged into an AC outlet even when not in use.)
Car Battery Cord (Optional)
Car Battery Cord
Cigarette
(optional)
Lighter Plug
1
Connect a PV-C16 Car Battery Cord
(optional) to the DC IN of the
Palmcorder.
Start your car engine and then insert
the Car Battery Cord plug into your
cigarette lighter socket.
• There is a fuse located in the lighter plug
end of the cord.
Should fuse replacement be necessary
use the exact current rating (in amps).
Note:
• This cord can only be used in vehicles
equipped with DC 12V (negative ground)
batteries. Use only the specified car battery
cord. If you are not sure check with your local
car/truck dealer as to what type of DC battery
ground you have in your vehicle.
• Be sure to start your car engine before
inserting the cigarette tighter plug of the
Car Battery Cord into the lighter socket;
otherwise, the cigarette lighter plug fuse
may burn out.
• Because the car is running while your
Palmcorder is in operation, make sure
you're in a well ventilated area.
• Disconnect the cigarette lighter plug when
your Palmcorder is not being used.
9
Advertisement
Table of Contents
