Using Your Exp 9200 Intercom - Uniden EXP 9200 User Manual

Example: Store 555-1234, plus tone number 765-4321 in memory
location 18:
a. Press MEMO
b. Press 5551234
c. Press RDL/P (To enter delay between numbers)
d. Press
e. Press 7654321 (Number entered in Tone Mode)
f. Press MEMO
g. Press 18. Base Unit beeps confirmation and the TALK LED goes out.
Erasing a Stored Number
1. On the Base Unit, press MEMO twice .
2. Press the memory location number or the ONE-TOUCH DIALING button you
want to clear. You will hear a long beep confirming the number is erased.

Using your EXP 9200 Intercom

The RING ON/BATT SAVE switch on the Handset must be in the
Note:
" RING ON"position. The Base Unit RINGER/VOLUME switch must be set to
either " LO" or "HI." (Note: When a call is ON HOLD at the Handset
and the Base Unit is paged, the Base Unit will ring even when the
RINGER/VOLUME switch is set to "OFF . " )
Paging from the Base Unit to the Handset
1. Press INT'COM. (If no answer, press INT'COM again to disconnect.)
2. Press TALK or INT'COM on the Handset to answer the page. Speak into the
mouthpiece.
3. To turn off the Intercom, press SP. PHONE on the Base Unit.
— OR —
Press TALK on the Handset.
Paging from the Handset to the Base Unit
1. Press INT'COM on the Handset. (If no answer, press INT'COM to disconnect.)
2. At the Base Unit, press SP. PHONE or INT'COM to answer the page. Speak
into the microphone.
3. To turn off the Intercom, press SP. PHONE at the Base Unit.
—OR—
Press INT'COM on the Handset.
/TONE (Switches to Tone Mode; counts as one digit.)
21