3-Way Conferencing; Using Your Dx8200 Intercom - Uniden DX8200 Instructions Manual

3-Way Conferencing

This feature lets you add a third party to your conversation. You can use the
keys on either the Handset or the Base Unit.
The DX8200 must first be connected with two separate telephone lines.
For example, to add a party to the current call on line 1:
1. Press hold to place the call on hold.
2. Press line 2 .
3. Dial the number of the person you want to add to the conversation.
When that person answers, you can speak privately before bringing the
original call back on the line.
If the third person's number is busy or doesn't answer, return to the
original call by pressing line 1
Press the conf button to bring the original call back on line.
4.
To remove either call from your conversation, press the line number ( line 1
5.
or line 2 ) of the call that you want to remain connected to.
The other call is disconnected.
When you hang up the DX8200 , all calls are disconnected.
6.

Using your DX8200 Intercom

The Base Unit ring vol switch must be set to either " lo " or " hi . "
( Note: When a call is on hold at the Handset and the Base Unit is paged, the
Base Unit will ring even when the ring vol switch is set to " off . " )
Paging from the Base Unit to the Handset
1. Press int'com . (If no answer, press int'com again to disconnect.)
2. Press talk or int'com on the Handset to answer the page. Speak into the
mouthpiece.
To turn off the Intercom, press speaker on the Base Unit.
3.
Press talk on the Handset.
Paging from the Handset to the Base Unit
Press int'com on the Handset. (If no answer, press int'com to disconnect.)
1.
At the Base Unit, press speaker or int'com to answer the page. Speak into
2.
the microphone.
To turn off the Intercom, press speaker at the Base Unit.
3.
32
— OR —