Resetting Handsets; Setting Up The Phonebook; Creating Phonebook Entries - Uniden DCT756 Owner's Manual

Resetting Handsets

If you want to register a handset to a different base or replace a handset with an-
other one, you must fi rst clear the registration information from the base and the
handset.
1. Press and hold [ ] and [#/>] on the handset for at least 5 seconds until the
SYSTEM RESET menu appears. Select the DEREGISTER HS submenu.
WHICH HANDSET? appears.
2. Move the cursor to select the handset ID to be de-registered from the list, and then press
DEREGISTER HS appears.
3. The phone asks you to confi rm the deregistration. Move the cursor to select YES, then press
confi rmation tone sounds. The handset clears the registration information from the base and then deletes its
own link to the base. The handset now displays MODELS VARY! CHARGE HANDSET ON THE BASE FOR
REGISTRATION OR REFER TO OWNER'S MANUAL. To register the handset to a base see page 24.

Setting up the Phonebook

Your phone lets you store up to 100 names and numbers in your phonebook in
the handset. Your phone shares memory between your phonebook and CID en-
tries. Once you store 100 phonebook entries, CID information is not stored and
only appears during a new incoming call. When phonebook and CID entries are
full, a beep sounds and MEMORY FULL appears. You cannot store any additional
names and numbers unless you delete some of the existing ones.
You can also use the phonebook to store a group of numbers (up to 20 digits)
that you may need to enter once your call connects. This is referred to
as chain dialing.

Creating Phonebook Entries

To store names and numbers in your phonebook, follow these steps:
1. When the phone is in standby mode, press [
2. To create a new phonebook entry, move the cursor to select STORE NEW.
3. Press . STORE/EDIT NAME appears.
4. Enter the name for this entry (STORE/EDIT NAME). Use the
].
25
.
. A