Resetting Stations; Registering Handsets; Adapter And Battery Information - Uniden D3288-2 User Manual

Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adapter & phone
cord from the wall before touching it.
If the liquid is only on the exterior housing of the base or handset, wipe it off and
use as normal. If you can hear liquid inside the housing:
1. Remove all compartment covers, and disconnect all cables and cords.
2. If liquid is leaking from any vent or hole, turn the phone so that vent faces down.
If not, place the largest vent face down.
3. Let dry for at least 3 days. Check for liquid inside the phone before replacing
compartment covers & reconnecting cords.

Resetting Stations

If you have problems with the base, unplug the base to reset it. Plug it back in after at
lease a minute. If you have problems with a cordless handset or want to replace one,
reset it:
1. Press & hold
enD
2. If you still have the base the handset is registered to, select
select the handset you want to reset. If you don't have that base anymore, select
Base Unavailable.
3. To confirm, select Yes. The handset displays

Registering Handsets

If you see a "not registered" message on a handset, you must register it to a base
before using it.
1. On the base, open the menu and select
On the handset, press and hold #; the handset displays Registering.
2.
3. Wait until the display says
the handset; press

If you don't hear a dial tone or the display says
the battery completely, then try again.

Adapter and Battery Information

AC adapter Base
Part number PS-0034
Input voltage 120V AC, 60 Hz
7.8V AC @
Output voltage
450mA
Use only the supplied AC adapters.

Use the proper adapter for the base & any

chargers.
Do not place the unit in direct sunlight or subject

it to high temperatures.
and # at the same time until you see the
Registration Complete
.
HOMe/flasH
Charger
PS-0035
8V AC @
300mA
System Reset
Handset not registered.
Register Accy.
(about 30 seconds), then pick up
Registration
Battery pack (with normal use)
Part number
Capacity
Talk time
Standby time
Battery life
Replace the battery when the talk or standby time

becomes noticeably reduced. For replacements,
call the Parts Department (see the front cover).
menu.
Deregister HS, then
Failed, charge
BT-1022
300mAh, 2.4V DC
about 7 hours
about 7 days
about 1 year
English -