Resetting Stations; Registering Handsets - Uniden Elite 9145 Owner's Manual

Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adapter and
phone cord from the wall before touching it.
If the liquid is only on the exterior housing of the base or handset, wipe
it off and use as normal. If you can hear liquid inside the housing:
1. Remove all compartment covers, and disconnect all cables and
cords.
2. If liquid is leaking from any vent or hole, turn the phone so that vent
faces down. If not, place the largest vent face down.
3. Let dry for at least 3 days. Check for liquid inside the phone before
replacing compartment covers and reconnecting cords.

Resetting Stations

If you have problems with the base, unplug the base to reset it. Plug it
back in after at lease a minute. If you have problems with a cordless
handset or want to replace one, reset it:
1. Press and hold
Reset menu.
2. If you still have the base the handset is registered to, select
HS, then select the handset you want to reset. If you don't have that
base anymore, select
3. To confirm, select

Registering Handsets

The base can register up to 10 handsets. If you see a "not registered"
message on a handset, you must register it to a base before using it.
1. On the base, open the menu and select
2. On the handset, press and hold #; the handset displays
3. Wait until the display says
then pick up the handset; press
#
If you don't hear a dial tone or the display says
charge the battery completely, then try again.
36
Elite9145om_20110115.indd 36
# at the same time until you see the
and
eND
Base Unavailable.
Yes. The handset displays
Registration Complete
HOMe/flasH
Handset not
Register Accy.
Registering.
(about 30 seconds),
.
Registration
System
Deregister
registered.
Failed,
28/9/11 12:14:50 PM