Table of Contents
Advertisement
CAUTION! Risk of explosion
if battery is replaced by an
incorrect type! Dispose of used
batteries according to the
instructions. Do not open or
mutilate the battery. Disconnect
the battery before shipping this
product.
For more details, see the
Important Information section.
GETTING STARTED
Installing Your Phone
Charge the Battery
1.
Unpack all handsets,
battery
packs, and
battery
covers. If
you need
to remove
a cover, press in on the notch
and slide the cover down and
off.
2.
Line up the battery connector
with the jack inside the
handset; the connector only fits
one way.
3.
Push the connector in until
it clicks into place; tug gently
on the wires to make sure the
battery is securely connected.
4.
Replace the battery cover and
slide it into place.
5.
Use an AC adapter to connect
the power jack on the base to
a regular indoor (120V AC)
power outlet. Connect any
chargers the same way.
6.
Place a handset in the base with
the display facing forward. If
the display doesn't light up,
reseat the handset or connect
the base to a different outlet.
For 2 or more handsets, place
each handset in a charger.
Charge all handsets
completely (about 15 hours)
before using.
Connect the Telephone Cord
Use the telephone cord to connect
the
jack on the base to a
TEL LINE
standard telephone wall jack.
Test the Connection
1.
Pick up the handset and press
. The handset sounds a dial
Talk
tone, and the display shows
Talk.
–
If you don't hear a dial tone or
the display says
check the connection between
the base and the phone jack.
2.
Make a quick test call. (Press
to hang up.)
End
–
If you keep hearing a dial tone,
change to pulse dialing.
–
If there's a lot of noise, check
for interference (see p. 22).
3.
Test all handsets the same way.
If you can't get a dial tone,
move the handset closer to the
base.
Check Tel Line,
English -
Advertisement
Table of Contents
