Start Here! Quick Start Guide - next page Digital Spread Spectrum provides the longest range, the clearest sound and the best privacy. QUICK START GUIDE...
INSTALLATION & SAFETY Choosing the best location for your DS815 When choosing a location for your phone there are a number of appliances the phone should not be near, and areas you should avoid. CHOOSE - This symbol indicates a central location important operating and AVOID - servicing instructions.
Start Here! Quick Start Guide Installing NOTE the Base Unit Use only the Uniden AC Adaptor supplied with Plug the phone jack into the Base Unit, then into the telephone this unit. connector to the wall. Make sure the AC...
Installing the Handset Battery Press the battery cover and slide it off. Connect the battery plug to the socket at the rear of the battery compartment. Make sure the plug is the right way round. The RED and BLACK battery wires must match the RED and BLACK printed on the phone case for the plug to fit properly.
CONTENTS Installation & Safety ii, iii Quick Start Guide Contents Controls & Functions 2, 3 Introduction Welcome Features Included in your Package Battery Maintenance Battery use time (per charge) When the Battery Charge becomes Low Cleaning the Battery Contacts Adjusting the Ringer and Earpiece Volume Installing the Belt Clip Headset Installation Using Your New Phone...
Page 7
Charging contacts Base unit aerial Status LED Page key Telephone line DC In 9V Registration key Rear of Base Unit Top of Base Unit status page 900MHz DIGITAL SPREAD SPECTRUM...
WELCOME Congratulations on your purchase of the Uniden DS815 cordless telephone. This phone is designed for reliability, long life and outstanding performance utilising the latest in 900 MHz Digital Spread Spectrum Technology. FEATURES 900MHz Digital Spread Spectrum Technology Multi-Handset operation...
The high quality rechargeable batteries supplied with your phone perform for up to two years or more. In order to enjoy the best performance from your phone, we discharged. recommend you replace your batteries every two years with a genuine Uniden Battery. Simply order a replacement battery from: Uniden Australia PTY Limited...
ADJUSTING THE RINGER AND EARPIECE VOLUME Ringer tone and volume The phone has four ringer tone and volume RINGER A HIGH combinations. In the standby mode, press on the handset repeatedly. The display shows the setting. Earpiece volume Pressing during a call will change the TALK LOUD earpiece volume of the handset.
MAKING AND RECEIVING CALLS Basic phone operation When Handset When Handset On Base Off Base 28/09 12:30 JIM STATEN 02 9597 9035 memory flash button talk talk g h i j k l pqrs t u v oper tone options select/ delete channel To answer...
CALL TRANSFER During a call, you can transfer the call to another optional handset (maximum 7 handsets). 1. Press delete/page TRANSFER TO NOTE 2. Press handset No. HAND # (1 - 7) The hanset number is shown on the right side of If the called handset is not the display.
Redial from talk mode TALK LOUD 1. Press talk NOTE redial/p 2. Press - the last number dialed will be displayed and redialed. Only the last number dialed can be accessed TALK LOUD after talk has been 95979035 pressed. TRAVELLING OUT OF RANGE During a call, noise will increase if you move your handset too far from your base unit.
STORING PHONE NUMBERS AND NAMES Memory Dialing allows you to dial a number using just a few key strokes. You can store up to 29 phone numbers in the memory. MEMORY STORE Since each step must be completed within 10 seconds, it may be advisable to review these 01 EMPTY instructions before starting.
MAKING CALLS WITH MEMORY DIALLING Memory Dialling from Standby memory 1. Press once, the handset displays 01 FRED your programmed memory locations. 02 JOHN SMITH 2. Press or enter a two-digit 03 KAY JONES number ( ) to select the memory location you would like to dial.
EDITING A STORED NAME AND PHONE NUMBER memory 1. Press and hold until MEMORY STORE MEMORY STORE is displayed. 01 FRED 2. Press or enter a two-digit number 02 JOHN SMITH ) to select the memory location you would like to edit. 3.
REGISTRATION The original handset supplied with the Main Base is already registered as handset 1, this leaves handset numbers 2 - 7 available. It is very important to allocate each handset a different number to enable functions such as Call Transfer. Registration Process Follow this process for each additional handset (DS805) that needs to be registered to the Main Base If a handset is registered at...
CALLER ID You must subscribe to the Caller ID service from your local telephone company to use these features. When the telephone rings, the Caller ID feature allows you to view the caller’s name NOTE and phone number on the display before you answer the phone. The handset displays the phone number of the incoming call, the name, time and the number of calls.
Viewing the Caller ID Message List The Caller ID list stores information for up to 60 incoming calls-even unanswered calls. 1. Press - the summary screen is displayed. HANDSET 1 The screen shows the number of new NEW 1 messages and total messages. TOTAL 3 2.
Using the Caller ID List 5/11 12:30 PM Calling a party from the Caller ID list FRED You can place a call from the Caller ID list. 02 9597 9035 The DS815 stores up to 60 messages. 1. Press - select the phone number that you want to dial by pressing TALK LOUD...
TROUBLE SHOOTING Re-register the handset - see page 14 Talk flashes No dial tone Cannot dial out Dial Prefix may be incorrectly set - see page 20 to delete Dial Prefix. Disconnect some telephones...
(D) Repaired by someone other than an authorised Uniden Repair Agent for a defect or malfunction covered by this warranty, (E) Used in conjunction with any equipment or parts or as part of a system not manufactured by Uniden. (F) Only available in the original country of sale.