Trunked Highway Frequency - Uniden BCT8 User Manual

Trunked Highway Frequency

Trunked Highway frequencies are pre-programmed for each
state. When the scanner finds the control channel data, the
scanner begins to find any active IDs. If the scanner finds any ID,
the active ID appears on the display and you will hear it.
If you press the L key while monitoring an ID, the scanner will check to see if any other IDs
are active. If none are active, scanning resumes.
When the scanner finds a control channel, it will stay on that control channel until reception
of the control channel is lost. To force the scanner off of the trucking control channel, press
DATA.
If you press the M key while a talk group ID is active, the
frequency on which talk group is transmitting flashes on the
display.
Or press and hold the M key for two seconds, and the ID and the frequency alternately
appears on the display. To return to the normal display, press the M key again.
Like conventional scanning, you can lockout reception of unwanted traffic.
You can lockout up to 30 IDs. Press L/O on the ID you want to lockout.
If you lockout 31st ID, the 1st ID already locked out is restored.
If you want to restore all the locked out IDs, pres and hold L/O for two seconds.
Or, when the state code is changed, all lockout IDs are restored as soon as scanning starts.
If you find an interesting ID you want to continue listening to,
press HOLD/RESUME.
Press HOLD/RESUME to resume scanning.
You can set the scanner to hold on an ID for two seconds to wait for a replay before
scanning resumes. While trunking, press DELAY. "DLY" appears on the display.
20