Uniden BCT8 User Manual page 23

Warning system with 800 mhz trunktracker iii
Hide thumbs Also See for BCT8:
Table of Contents

Advertisement

You will experience a slight in the conversations you hear as the
Priority channels. You can cancel the priority check and the interruptions in the
conversations by pressing HOLD/RESUME to hold on the frequency.
Note: The Highway Warning Alert is inoperative while the scanner is on Hold.
Remember to press HOLD/RESUME to return to normal priority-scan operation.
Priority channel cannot be changed, but you can lock-out priority channels using L/O.
Priority channels have been pre-determined by the manufacturer as those Highway Patrol
frequencies most commonly used for mobile extenders and for car-to-car and aircraft-to-car
operations. Mobile extenders re-transmit every radio broadcast received on the patrol car
radio to the officer's walkie-talkie at low-power. Every time any officer or dispatcher talks
(transmits), the signal is broadcast like a beacon at low-power whether or not the officer is
out of the car.
You can select Priority Scanning mode by pressing PRI.
• Normal Priority Scan mode.
The scanner checks the Priority frequency every two seconds. "PRI" will be displayed.
• Priority only mode.
To only monitor the priority frequencies, press and hold PRI to select Priority Only. This
mode is especially recommended for the following states:
(Arizona)
(Delaware)
(Florida)
"PRI" flashes when you select Priority Only Mode.
• Priority off mode
The scanner does not check the Priority frequency. "PRI" will not displayed.
(Michigan)
(Oklahoma)
(Wisconsin)
19
scanner checks the

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents