Using Limit Search; Programming The Limit Search Range Upper/Lower Limits; Searching The Selected Range; Holding On A Frequency Within The Limit Search Range - Uniden BC365CRS Owner's Manual

USING LIMIT SEARCH

There are three Limit Search modes:
x Program Search Range. This mode allows you to set the upper and lower
limits of your search range.
x Limit Search. This mode will search for active frequencies within the upper
and lower limits designated. It will stop when it locates a frequency.
x Limit Search Hold. During Limit Search mode, press HOLD/Sleep to stop
searching with the serach range regardless of whether you have found
transmission. Press HOLD/Sleep or SEARCH/AM to resume searching.

Programming the Limit Search Range Upper/Lower Limits

1. Press SEARCH then HOLD. The scanner holds on the current search
frequency.
Enter one of the range limits, then press E/PGM.
2.
3. Press ▲ or ▼ then enter the other range limit, and press E/PGM.

Searching the Selected Range

After entering the limits (or use the default limits), press SEARCH. The
scanner starts searching from the lower range up to the higher range.
To change the direction of the search, press ▲ or ▼.

Holding on a Frequency within the Limit Search Range

In Limit Search mode, press HOLD/Sleep.The scanner holds on the
1.
current frequency regardless of its transmission state.
2. Press ▲ or ▼ to change the direction of the search if desired.
Press HOLD/Sleep again or SEARCH/AM to resume searching.
3.
SAVING A FOUND FREQUENCY INTO A CHANNEL
1. When the scanner stops on the frequency you want to save, press HOLD
to hold on that frequency.
2. Press E/PGM. The scanner displays the lowest-numbered empty channel
(or channel number 1 if all channels are used).
3. Use ▲/▼ to select the channel to store the frequency, then press E/PGM
to store the frequency into that channel.

SEARCH LOCKOUTS

If the scanner stops on a frequency that you don't want to hear, you can lock it
out. When locked out, the scanner won't stop on the frequency in either Limit
Search or Service Search.
Press L/O when the scanner stops on the frequency to lock it out. L/O
displays.
To unlock the frequency:
1. press HOLD during a Search.
2. Manually step to the frequency using the ▲/▼ keys.
3. When you have selected the locked out frequency, press L/O to unlock it.
24