Table of Contents
Advertisement
Select the bank(s) to be programmed.
The indicators of
the selected banks stop flashing.
Note:
If the selected bank is full, that is, all 20
channels
are programmed,
"FULL:'appears
on the
display. In this case, select
another bank.
Press [SRC] to start programming.
On the display, only the indicators of the selected banks
remain. The indicator of the bank currently being
programmed starts blinking. The channel currently
being stored is also displayed.
Note: During AUTO STORE,
the search
does not stop
on any active channel.
You will not hear any audio, and
no duplicate frequency
will be stored.
TO STORE stops automatically when all available channels
.he selected banks are stored. "FuLL:' appears, and the last
:mnel stored is displayed.
stop AUTO STORE manually, press [HLD], [MANUAL],
[AUTO].
The last channel number and its frequency are
;played.
. Transferring a Programmed
Frequency to
~nother Open Channel
his feature allows you to reassign a stored frequency to
nother bank's open channel.
Note:
You cannot transfer a Priority
Channel (preceded by
a uP" on the display).
You must assign the Priority to
another channel
in the same bank before transferring the
frequency.
(Priority Channels are described later in "Setting
Up Priority Channels".)
I
1.
Press [MANUAL]
to stop scanning.
3.
Use the Rotary Tuner (or any other previously
described method) to select a programmed channel.
Press [SND] to activate the Transfer feature.
All bank indicators start flashing on the display.
Press the numeric key(s) of the selected bank.
Only the indicator of the selected bank remains on the
display. The bank's
lowest
open channel flashes,
waiting to be programmed.
Press [E] to complete the transfer.
2.
4.
5.
The frequency is now stored in the new channel, and
the old channel is empty.
21
Advertisement
Table of Contents
