Adjusting The Transmit Power; Using Scan; Using All Channel Scan - Uniden UM625C Owner's Manual

Adjusting the Transmit Power

Press HI/LO/SCRAMBLER to adjust the transmit power. If the transmit power on the cur-
rently tuned channel is set to Hi (25W), pressing HI/LO/SCRAMBLER changes it to Lo (1W),
and appears on the display. If the transmit power on the currently tuned channel is set to
LO
Lo, pressing HI/LO/SCRAMBLER changes it to Hi, and
Important: The radio automatically sets itself to low transmit power if you tune to Channels
13, 67, 75, 76, 77 based on FCC rules. You cannot change the transmit power to high on
Channel 75 or Channel 76. You can, in an emergency, overide the default setting on Channel
13 or Channel 67. Press Hi/LO/SCRAMBLER while holding in the PTT switch to switch to
high.
Notes:
• You cannot change the transmit power while the radio is set to Scan mode.
• The radio automatically sets itself to high transmit power if you use PUSH/SELECT to tune
to Channel 16, press 16/9 TRI, or it receives a distress call. The radio sets itself back to
low power if you use PUSH/SELECT to select another channel.

Using Scan

Note: If you hold down STEP/SCAN while the radio is set to WX mode or Coast Guard/
Distress/Hailing mode, it cancels that mode and starts memory channel scanning.
Using Triple Watch Scan
Triple Watch lets you easily scan emergency channels along with a channel you select.
To use Triple Watch scan, hold down STEP/SCAN for about 2 seconds. The radio scans
Channel 16, Channel 9, and the current memory channel.
Using Normal Scan
Normal scan lets you quickly scan and tune only selected channels. To use normal scan, set
the radio to Triple Watch scan then hold down 16/9 TRI for about 2 seconds. The radio scans
any channels you saved in memory and SCANNING appears.
Notes:
• If you use normal scan, the radio scans all channels except emergency channels. Use
Triple Watch scan (see "Using Triple Watch Scan") to scan emergency channels.
• You must save at least two or more channels in the radio's memory to use memory scan.
See "Saving Channels in Memory" on Page 22 for more information.

Using All Channel Scan

In RADIO SETUP, set CHANNEL SCAN to ALL CH. Then, press and hold 16/9/TR for 2 sec-
onds during a Triple Watch scan setting. All channels are scanned except Emergency 16 and
Emergency 9.
Basic Operation
HI appears.
appears on the display.
TRI
19