Related Manuals for Uniden UH075
Summary of Contents for Uniden UH075
- Page 1 UT01913ZZ_1 11/21/03 5:50 PM Page i Operating Guide To bring outstanding wireless communication products to people's lives throughout the world.
-
Page 2: Lithium Ion Battery Pack Warning
"...the unit is able to withstand a steady stream of water from a hose for 5 minutes without leakage..." The UH075 will only meet this rating if fully assembled and all rubber seals and bungs are well maintained and correctly fitted. This means that the speaker microphone bung is inserted, and the battery pack and antenna are attached and securely fastened. -
Page 3: Table Of Contents
Using a Repeater Channel ........12 To Operate UH075 in Duplex Mode ......13 Scanning . -
Page 4: Features
Page 2 INTRODUCTION The UH075 is a JIS4 Waterproof, portable two-way UHF-CB radio. It is compact, rugged and fits easily in your hand. This hand held UHF radio will give you consistent, outstanding performance in virtually all conditions and situations. To ensure that you get the most from the UH075 features, please read this operating guide carefully before using the unit. -
Page 5: Included In Your Package
Page 3 INCLUDED IN YOUR PACKAGE AC Adapter Antenna UH075 (AAD-075S) Drop-in Charger Lithium Battery Beltclip (DT075) (BP075) Reference Guide/ Printed Material Wrist Strap Mounting Screws If any of these items are missing from the box, contact your Uniden Dealer, immediately. -
Page 6: Getting Started
When you mount the drop-in charger in a mobile vehicle, use the optional cigarette lead instead. Attaching the Antenna Attach the antenna to the UH075. Be sure the antenna is firmly seated. 5:50 PM Page 4... -
Page 7: Attaching The Battery Pack
2. Snap the battery release clip until it clicks. Be sure the battery pack fits tightly against the UH075 body. Avoid exposing the Lithium Ion battery, attached or unattached to the radio, in direct sunshine, heated cars, or in areas with temperatures below –20°C (–4°F) or above +60°C (+140°F). -
Page 8: Charging The Battery Pack
The charger won’t overcharge the battery pack. When charging is completed, the charge LED is no longer illuminated. • Do not transmit when the UH075 is in the drop-in charger! • You can monitor incoming calls while the UH075 is in the drop-in charger. 5:50 PM Page 6... -
Page 9: Battery Level Display
UT01913ZZ_1 11/21/03 Battery Level Display The BATTERY icon in the top right hand corner of the screen indicates the UH075 current battery voltage level at all times. The battery level is displayed in 4 levels. LEVEL 4 Battery 100% full LEVEL 3 Battery approx. -
Page 10: Operation
UT01913ZZ_1 11/21/03 5:50 PM Page 8 OPERATION ➤ See the Controls and Indicators page at the back of this operating guide for button and key operations. POWER ON/OFF To turn the unit ON, rotate the [ON/OFF VOL] clockwise. A channel number and battery level should appear on the display. -
Page 11: Roger Beep
UT01913ZZ_1 11/21/03 ROGER BEEP Roger Beep is a BEEP that is sent to notify the end of transmission (both PTT and VOX transmission.) Roger Beep can be heard through the speaker when Key Beep is on. Roger Beep is transmitted even if key beep is turned off. However Roger Beep will not be heard from the speaker. -
Page 12: Squelch
In this case, simply rotate the [SQ] clockwise until the weak signal is heard clearly. 5:50 PM Page 10 UH075 UHF-CB radio. Strong Signals Medium Signals Weak Signals Noise... -
Page 13: To Transmit And Receive
UT01913ZZ_1 11/21/03 TO TRANSMIT AND RECEIVE The UH075 uses the 40 UHF-CB Channels. For your reference a list of the available channels and corresponding frequencies is printed at the end of this manual. 1. The maximum RF transmit power of UH075 is 5 watts. -
Page 14: Using A Repeater Channel
With Duplex operation, the signal coming from your radio is received by the Repeater station and then re-transmitted at the same time on another channel. Your UH075 is designed with duplex capability on Channels 1 to 8. When any of these channels are set to operate in duplex mode during transmission, the UH075 automatically sends the signal at a frequency 30 channels above the original in order to access the repeater station. -
Page 15: To Operate Uh075 In Duplex Mode
UH075 will return to simplex operation. Check with your local retailer for available repeaters. SCANNING The UH075 has two types of scanning; Open Scanning (OS) and Group Scanning (GS). Scanning allows you to search for active channels programmed in the OS or GS memory. -
Page 16: Group Scan (Gs) Mode
To deactivate SCAN, press the If SCAN is deactivated while it is turned to an active channel, the UH075 will stay on that active channel. If none of the channels are active, the UH075 will reinstate the Priority channel. 5:50 PM... -
Page 17: Programming Scan Channels
, to select a lower channel. DROP-OUT DELAY While scanning, the UH075 stops at a busy channel and receives a transmission. When the received signal is over, the unit will wait for 3 seconds for the return of the signal, otherwise, the radio resumes scanning. -
Page 18: Advanced Features
2. Press and hold 3. When a signal is sensed on a CTCSS CH, the UH075 stops for about 400 msecs (decode time) to decode the CTCSS code. If there is no code or the receive code does not match the one programmed on the unit, the unit resumes scanning. - Page 19 UT01913ZZ_1 11/21/03 VOX feature will not work without the Vox Headset Microphone. The built in mic of UH075 is temporarily disabled, however accidental pressing of To activate VOX 1. Press and hold blinks. 2. Press either select the desired VOX sensitivity level (9 with the lowest sensitivity to 1 with the highest sensitivity).
-
Page 20: Power Save
UT01913ZZ_1 11/21/03 ➤ POWER SAVE Battery Save feature extends the battery life by switching the receiver circuit power ON and OFF. This feature automatically activates during standby mode (RX mode without signal). ➤ BACK LIGHTING The Liquid Crystal Display (LCD) and function keys are backlit for easy viewing at night or in low light situations. -
Page 21: Busy Channel Lock-Out (Bcl)
UT01913ZZ_1 11/21/03 ➤ BUSY CHANNEL LOCK-OUT (BCL) This feature prevents accidental transmission on a busy channel. This is recommended on channels where CTCSS is being used. If the channel is "active" and the signal is coming from a non or different CTCSS code user the BCL feature will prevent you from transmitting. -
Page 22: Uhf Channel And Frequencies
UT01913ZZ_1 11/21/03 UHF CHANNEL & FREQUENCIES Simplex Mode CH No. Transmit / Receive Frequency (MHz) 476.425 476.450 476.475 476.500 476.525 476.550 476.575 476.600 476.625 476.650 476.675 476.700 476.725 476.750 476.775 476.800 476.825 476.850 476.875 476.900 Channel 05 and 35 are Emergency Channels and channel 11 is a Calling Channel. -
Page 23: Ctcss Codes And Frequencies
UT01913ZZ_1 11/21/03 CTCSS CODES & FREQUENCIES Code No. Freq. (Hz) 00("oF") 67.0 71.9 74.4 77.0 79.7 82.5 85.4 88.5 91.5 94.8 97.4 100.0 OPTIONAL ACCESSORIES • VOX Headset • Speaker Microphone 5:50 PM Page 21 Code No. Freq. (Hz) Code No. 103.5 107.2 110.9... -
Page 24: Specifications
UT01913ZZ_1 11/21/03 SPECIFICATIONS General Channels Oper. Temp. Antenna Microphone Display Speaker Power Source Size Weight Transmitter Frequency Control Frequency Range Frequency Stability Power Output Spurious Emissions Current Drain Receiver Receive Type Frequency Range Sensitivity @12 dB SINAD Squelch Sensitivity Audio Frequency Response (ref: 1 KHz, ±... - Page 25 UT01913ZZ_1 11/21/03 Audio Output Drain Current Drain Charger Std. Power Supply Specifications shown are typical and subject to change without notice. 5:50 PM Page 23 0.6 W (10% THD) Squelched 40 mA Max. Audio 170 mA AAD-075S Input 230 – 240 V AC, 50 Hz Output 9 V, 210 mA Approval No.
-
Page 26: Warranty
Elements of Warranty: Uniden warrants to the original retail owner for the duration of this warranty, its UH075 UHF CB Transceiver Radio (hereinafter referred to as the Product) to be free from defects in materials and craftmanship with only the limitations or exclusions set out below. -
Page 27: Controls And Indicators
UT01913ZZ_1 11/21/03 CONTROLS & INDICATORS 1 Antenna 2 Belt Clip 3 Battery 4 Battery Release Clip 5 PTT (Push to Talk) Key 6 Memory Key (mem) 7 Scan Button (scan)/Busy Channel Lock-Out Mode (bcl) 8 TX Power/Lock Button (1/5w/lock) 9 Microphone 10 Speaker MIC (Optional) Jack 5:50 PM Page 25... -
Page 28: Lcd Display
UT01913ZZ_1 11/21/03 LCD Display Transmit 1W Power Duplex Transmit D Scanning Monitor Priority Busy Channel Lock Out H Group Scanning Channel Numbers 5:50 PM Page 26 CTCSS Roger Beep M Battery Level Indicator Key Lock O Memory Receive... - Page 29 UT01913ZZ_1 11/21/03 5:50 PM Page 27 Note:...
- Page 30 UT01913ZZ_1 11/21/03 5:50 PM Page 30 ©2003 Uniden Australia Pty Limited/Uniden New Zealand Limited Part Code UTZZ01913ZZ Printed in China...
Need help?
Do you have a question about the UH075 and is the answer not in the manual?
Questions and answers