KTM 250 EXC-F 2013 Owner's Manual page 100

17 SERVICE WORK ON THE ENGINE
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
101469-10
–
Mount and tighten the oil drain plug
Guideline
Oil drain plug with magnet
101467-10
–
Insert the short oil screen
tighten.
Guideline
Plug for oil screen, short
100944-10
–
Place the long oil screen
Info
The larger inside diameter of the oil screen must face the engine case.
–
Push the pin wrench through the opening into the drill hole of the opposite engine
case wall and push the oil screen as far as possible into the engine case.
–
Mount and tighten the screw plug with the O-ring.
Guideline
101465-10
Plug for oil screen, long
– Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Fill oil filter
–
Oil the O-ring of the oil filter cover and mount it with the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
101470-10
–
Remove filler plug
reaches the upper edge of the level viewer.
Engine oil
101471-10
out of the oil filter housing.
6
1
into the screw plug, mount it with the O-ring and
2
M16x1.5
with the O-rings onto a pin wrench.
4
with engine oil and place it in the oil filter housing.
6
with the O-ring on the clutch cover and add engine oil until it
8
1.20 l (1.27 qt.)
with the magnet and a new seal ring.
M12x1.5 20 Nm
(14.8 lbf ft)
10 Nm Lubricated with
(7.4 lbf ft) engine oil
M20x1.5 15 Nm
(11.1 lbf ft)
M5 6 Nm (4.4 lbf ft)
Engine oil (SAE 10W/50) (
Alternative engine Engine oil
oil for harsh oper- (SAE 10W/60)
ating conditions (00062010035)
and increased per- (
formance
98
.
7
p. 114)
p. 114)