Connecting An Ethernet Cable To The Access Point - Cisco Aironet 1530 Series Hardware Installation Manual

Chapter 2 Installing the Access Point

Connecting an Ethernet Cable to the Access Point

You need to supply these tools and materials:
•
•
•
•
To connect the shielded Ethernet cable to the access point, follow these steps:
Disconnect power to the power injector, and ensure all power sources to the access point are turned off.
Step 1
Warning This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
Step 2 Ensure a 6 AWG ground wire is connected to the access point (see the
section on page
Step 3 Use a large Phillips or Flat Blade screw driver to remove the Ethernet connector plug from the access
point. Do not discard plug and rubber seal unless you are certain that the port will not have to be
re-plugged (see
Figure 2-25
1
Note
Loosen the Thread-Lock sealing nut of the cable gland by turning it counter clockwise, but do not
Step 4
remove it (see
OL-30864-01
Shielded outdoor-rated Ethernet (CAT5e or better) cable with 0.2 to 0.35 in. (0.51 to 0.89 cm)
diameter
RJ-45 connector and installation tool
Adjustable Wrench or 28 mm box wrench
Large Phillips or Flat Blade screwdriver
2-40).
Figure 2-25 for the location).
Access Point PoE-In Connector- AP 1532I
1
LAN port (covered)
For information on data cable entry, refer to
Figure 2-26).
Cisco Aironet 1530 Series Outdoor Access Point Hardware Installation Guide
"Grounding the Access Point"
2 PoE-in port (covered)
Figure 1-1
Powering the Access Point
2
2-43