Electrolux EWED65HSS Installation Instructions Manual page 23

Reversing Door 23
K) Reattaching Door to Front Panel
1 Use side locating pins to align hinge and 3 Rotate and move trim ring cover plate to
Install 1 short, fine-thread, counter-sunk opposite opening In trim and reinsert.
screw In center hole of hinge side.
M) Reinstalling Trim Ring
1 Close door.
2 Onent trim so 12 postion Is approximately
3" to the left of top center. Opening In ring
should be on the hinge side.
à Insert trim ring In slots and rotate clockwise
approximately 34".
2 Install other 2 short, ine-thraad, counter
SUNK screws In upper and lower holes of
hinge side.
8 Install 2 short, coursa-thread, panhead
N) Reinstalling Trim Plug
1 Open door to 90 degree angle.
2 Install trim plug with 1 long, coursa-tnread,
panhead screw.
4 lose door and test operation of latch.
L) Reversing Trim Ring
1 Thm ring onentation is marked on the back.
2 Remove tim rng cover plate. To remove
plate from lett, pivot point Is dawn. To
remove plate from right, pivot polnt Is up.
Q) Plug in dryer and continue operation.