Uart (External Modems Only) - US Robotics Sportster Operating Instructions Manual

For software flow control, select
XON/XOFF.
NOTE:
You may need to disable
the flow control (hardware or software)
that you are not using.
UART (External Modems)
If you are running Windows 3.x or you have
upgraded your system from Windows 3.x to
Windows 95, you can run MSD to determine
your UART setting. In DOS, type MSD at the
Windows directory prompt and then press
ENTER. Follow the on-screen instructions to
access the COM port settings panel. In this
panel you should find the UART chip used.
Match the UART type listed in MSD with the
serial rate listed in the chart below. Select this
62
I O F /D S
NSTALLING THER AX ATA OFTWARE
serial rate in any communications software you
use.
If this is your UART...
16550*
16450
8250
*All Sportster internal modems have a 16550 UART.
NOTE:
14,400, or 12,000 bps serial port rate, if
offered. Your modem will NOT work
correctly with any of these settings. Fix
or lock the serial port (baud) rate (if it's
referred to as autobaud, select OFF).
Select this
serial rate
115.2 or
57.6 kbps
38.4 kbps
19.2 kbps
DO NOT select a 28,800,