Yamaha YZ250X 2022 Owner's Service Manual page 55

1. Engine stop switch lead
2. Throttle cable
3. Clutch cable
4. Clamp
5. Throttle position sensor lead
6. Radiator breather hose
7. Air vent hose
8. Crankcase breather hose
9. Overflow hose
A. Pass the clutch cable on the outside of the
throttle cable and engine stop switch lead.
B. Align the throttle cable locating tape with the
cable guide.
C. Pass the throttle cable, clutch cable and
engine stop switch lead above the radiator
hose.
D. Clamp the engine stop switch lead to the
frame. Tighten the clamp so that the engine
stop switch lead is not pulled when the han-
dlebar is turned to the right and left.
E. Clamp the throttle cable, clutch cable and
throttle position sensor lead to the frame.
F. Clamp the throttle cable and throttle position
sensor lead to the frame.
G. Pass the clutch cable in front of the center of
the cylinder head tightening nut.
H. Pass the air vent hose, overflow hose and
crankcase breather hose between the frame
and connecting rod.
I. Locate the clamp ends in the arrowed range.
J. Pass the throttle cable behind the air vent
hose.
K. Pass the air vent hose, overflow hose and
crankcase breather hose so that they do not
contact the rear shock absorber.
L. Install the right-side clamp within the range
"N". (Installation position of the clamp: 50–70
mm (1.97–2.76 in) from the bracket)
M. Install the left-side clamp within the range "N"
similar to the right-side clamp. (Installation
position of the clamp: 80–110 mm (3.15–4.33
in) from the bracket)
CABLE ROUTING DIAGRAM
2-16