Yamaha YZ125 2019 Owner's Service Manual page 49

1. Engine stop switch lead
2. Throttle cable
3. Clutch cable
4. Ground lead
5. High tension cord
6. Clamp
7. Air vent hose
8. Radiator breather hose
9. CDI magneto lead
10. YPVS breather hose
11. Engine bracket (right)
12. Engine bracket (left)
13. Crankcase breather hose
14. Overflow hose
15. Connector cover
A. Pass the clutch cable on the outside of the
throttle cable and engine stop switch lead.
B. Align the throttle cable locating tape with
the cable guide.
C. Pass the throttle cable, clutch cable and
engine stop switch lead above the radiator
hose.
D. Install the ignition coil, side core and
ground lead together to the frame. Take
care to fasten the ground lead so that its
terminal is within the indicated range.
E. Clamp the throttle cable and high tension
cord to the frame.
F. Clamp the clutch cable to the left engine
bracket. Clamp the clutch cable below the
positioning grommet.
G. Pass the air vent hose back of the throttle
cable.
H. Pass the air vent hose, overflow hose and
crankcase breather hose between the
frame and connecting rod.
I. Pass the radiator breather hose and YPVS
breather hose outside the engine bracket
and inside the down tube. Then pass the
radiator breather hose inside the YPVS
breather hose.
J. Clamp the CDI magneto lead, radiator
breather hose and YPVS breather hose to
the frame.
K. Clamp to the frame the CDI magneto lead
and radiator breather hose. Take care to
clamp them above the projection on the
frame.
L. Locate the clamp ends in the arrowed
range.
M. Direct the clip with its finger grip facing for-
ward.
CABLE ROUTING DIAGRAM
N. Tighten the clamp with its bolt head facing
the left side of the chassis (on both sides of
the carburetor joint and the air filter joint).
O. Pass the air vent hose, overflow hose and
crankcase breather hose so that they do
not contact the rear shock absorber.
P. Bring the connector cover into contact with
the coupler.
2-18